The Best 300-610 Exam Study Material and Preparation Test Question Dumps
Get Ready to Pass the 300-610 exam Right Now Using Our CCNP Data Center Exam Package
Cisco 300-610 is an expert-level exam that is specifically designed to validate the skills and expertise of professionals in the field of designing Cisco data center infrastructure. 300-610 exam is one of the six exams leading to the highly sought-after CCNP Data Center certification. It is designed to help professionals gain specific knowledge and skills on how to design a Cisco data center network infrastructure.
NEW QUESTION # 17
An engineer must secure the payload traversing across the DCI. The solution must support confidentially and integrity and it must be open standard. The solution must encrypt Ethernet frames regardless of the upper layer protocol used. Which technology must be used to support these requirements?
- A. OTV
- B. IPsec
- C. GRE
- D. MACsec
Answer: D
Explanation:
The key to solution is "Ethernet frames". Frames are layer 2. IPsec encrypts at layer 3.
NEW QUESTION # 18
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
- A. FC switching mode
- B. FC end-host mode
- C. NPV mode
- D. NPIV mode
Answer: A
Explanation:
Switch mode is the traditional Fibre Channel switching mode. Switch mode allows the fabric interconnect to connect directly to a storage device. Enabling Fibre Channel switch mode is useful in POD models where there is no SAN (for example, a single Cisco UCS system connected directly to storage), or where a SAN exists (with an upstream MDS).
NEW QUESTION # 19
An engineer must build a VXLAN flood-and-learned network. The customer requires the solution to be based on the IETF documented practice in RFC 7348. The solution must use broadcast, unknown unicast, and multicast (BUM) and include the efficient BUM and short BUM replication modes that use only shared trees. Which technology meets these requirements?
- A. PIM sparse mode
- B. Bidirectional PIM
- C. MVPN
- D. PIM SSM
Answer: B
NEW QUESTION # 20
Cisco FabricPath is implemented in a data center. You plan lo implement anycast HSRP. What is an advantage of anycast HSRP as compared HSRPv2?
- A. An HSRP group can be secured by using MD5.
- B. HSRP gateways use BFD for faster failure detection
- C. Up to four HSRP gateways can forward traffic simultaneously.
- D. Up to six HSRP gateways can forward traffic simultaneously.
Answer: C
NEW QUESTION # 21
Drag the appropriate from the left onto the current UDLD modes of operation on the right.
Answer:
Explanation:
NEW QUESTION # 22
What are two reasons to select OTV as the DCI solution to connect multisite topologies? (Choose two.)
- A. Layer 3 failures do not propagate beyond the OTV edge device.
- B. It extends the spanning tree between data centers.
- C. It propagates hosts reachability without support of traffic flooding.
- D. It is an open standard.
- E. It constrains HSRP hello messages to each data center.
Answer: A,B
Explanation:
Section: Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Data_Center/DCI/whitepaper/ DCI3_OTV_Intro/DCI_1.html
NEW QUESTION # 23
An engineer finishes the initial set up of a VXLAN EVPN network. The engineer is asked to plan for external connectivity that supports redundancy and extends multiple virtual routing and forwarding domains. The requirement is to use the same default gateway addressing across all leaf switches that belong to the VXLAN network.
Which two solutions must be used to meet these requirements? (Choose two.)
- A. DC Interconnect
- B. Inter-Site Network
- C. VRF-Lite
- D. Distributed Anycast Gateway
- E. Spanning Tree Protocol
Answer: A,D
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
12/configuration_guide/vxlan/b_1612_bgp_evpn_vxlan_9300_cg/configuring_evpn_vxlan_anycas t_ gateway.html
https://www.cisco.com/c/en/us/products/collateral/switches/nexus-9000-series-switches/white- paper-c11-739942.html
NEW QUESTION # 24
A company runs mission-critical infrastructure in a single data center. Due to business growth, it plans to open more data centers in the coming years. A network engineer is asked to recommend a network technology for data center interconnection that allows scalability and seamless VM mobility while providing maximum security and fault isolation between data centers.
Which technology must be used to meet these requirements?
- A. UDLD
- B. TrustSec
- C. OTV
- D. CloudSec
Answer: C
NEW QUESTION # 25
An engineer must configure an interface for managing and orchestrating a Cisco Nexus device.
The interface must be operational if the data and control planes crash, support IPv4 and IPv6 addressing, and have access to its own VRF instance.
Which interface should be used to meet these requirements?
- A. physical interface
- B. interface VLAN
- C. loopback interface
- D. management interface
Answer: D
NEW QUESTION # 26
The data center aggregation layer that uses IPv4 and IPv6 address space must act as a redundant Layer 3 gateway The solution must support a minimum of 240 virtual groups for an interface The data center aggregation layer hosts network devices from different vendors Which FHRP solution meets these requirements?
- A. HSRPv1
- B. HSRPv2
- C. VRRPV3
- D. VRRPv1
Answer: C
NEW QUESTION # 27
A storage administrator receives reports of network delays when database software attempts to access the storage array. The virtual machines that host the database software are installed on different rack servers connected to the Cisco UCS Fabric Interconnect domain. The existing SAN switches are connected to the Fabric Interconnects using two 8 Gb port-channel interfaces to connect the storage array. The storage administrator has decided to deploy iSCSI storage with four 10 Gbps interfaces connected to the Cisco UCS Fabric Interconnects.
Which deployment type resolves the problems with storage contention?
- A. iSCSI storage with Cisco UCS Fabric Interconnect in the virtual port-channel mode
- B. iSCSI storage appliance on Cisco UCS Fabric Interconnect in the storage end-host mode
- C. iSCSI storage with Cisco UCS Fabric Interconnect using an appliance port
- D. iSCSI storage appliance on Cisco UCS Fabric Interconnect uplink trunk port
Answer: D
NEW QUESTION # 28
Which two vSphere features must be included in the design of a Cisco HyperFlex systems stretched cluster?
(Choose two.)
- A. VSS
- B. HA
- C. DRS
- D. FT
- E. VDP
Answer: B,C
Explanation:
Section: Compute Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/hyperconverged_systems/ HyperFlex_HX_DataPlatformSoftware/HyperFlex_Stretched_Cluster/3_5/ b_HyperFlex_Systems_Stretched_Cluster_Guide_3_5.pdf
NEW QUESTION # 29
An engineer is designing a disaster recovery solution. In the event of a node failure, the solution should either direct all of the traffic to another node, or load-balance the traffic across the remaining nodes.
Which solution should be implemented in the design?
- A. active/active
- B. active/passive
- C. warm standby
- D. cold standby
Answer: A
NEW QUESTION # 30
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.
Answer:
Explanation:
NEW QUESTION # 31
An ACI deployment must:
Which VRF configuration must be used?
- A. Option B
- B. Option C
- C. Option A
- D. Option D
Answer: B
NEW QUESTION # 32
An engineer must connect a Cisco UCS B-Series based system to an existing large storage area network fabric. The deployment must support hardware-based load balancing, prevent Fibre Channel domain ID exhaustion, and enable all blade servers to be in the same VSAN. Which set of actions meets the requirements?
- A. Option B
- B. Option C
- C. Option A
- D. Option D
Answer: B
NEW QUESTION # 33
Which two automation requirements can be met by using Puppet? (Choose two.)
- A. Enable clients to pull changes to configuration files.
- B. Push configuration updates immediately to servers.
- C. Provide support for writing new modules in Python.
- D. Enable clients to pull changes without installing an agent.
- E. Enable one-off infrastructure changes to be performed manually.
Answer: A,B
Explanation:
Section: Automation Design
Explanation/Reference: https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series- rack-servers/whitepaper_c11-740103.pdf
NEW QUESTION # 34
Which two vSphere features must be included in the design of a Cisco HyperFlex systems stretched cluster? (Choose two.)
- A. VSS
- B. HA
- C. DRS
- D. FT
- E. VDP
Answer: B,C
NEW QUESTION # 35
A network architect designs the iSCSI-based storage area network solution. The iSCSI datastore must be designed with high availability, minimal downtime, and no single point of failure. The requirement is to fail over I/O to alternate paths based on SCSI sense codes without reliance on network failures.
Which feature must be deployed to meet these requirements?
- A. NIC teaming
- B. port security
- C. hardware-based flow control
- D. iSCSI multipath
Answer: D
NEW QUESTION # 36
......
Get Special Discount Offer of 300-610 Certification Exam Sample Questions and Answers: https://actualtests.latestcram.com/300-610-exam-cram-questions.html
