[2021] Pass NSE7_SDW-6.4 Exam - Real Questions & Answers
NSE7_SDW-6.4 Exam Questions Get Updated [2021] with Correct Answers
NEW QUESTION 14
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It ensures route tags match the SD-WAN rule based on the rule order
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- D. It tags each route and references the tag in the routing table.
Answer: A
NEW QUESTION 15
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
- D. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
Answer: A,C
NEW QUESTION 16
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The dead member interface stays unavailable until an administrator manually brings the interface back.
- B. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- C. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- D. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
Answer: C
NEW QUESTION 17
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
- B. Place the troublesome link at the top of the interface preference list.
- C. Configure an SD-WAN rule to load balance all traffic without VoIP
- D. Use the performance SLA targets to detect latency and jitter instantly.
- E. Choose the suitable interface based on the interface cost and weight
Answer: D,E
NEW QUESTION 18
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. Dynamic VPN is not supported as an SD-Wan interface.
- C. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- D. ADVPN interface can be a member of SD-WAN interface.
Answer: D
NEW QUESTION 19
Refer to the exhibit.
Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)
- A. set cost 15.
- B. set priority 10.
- C. set source 100.64.1.1.
- D. set load-balance-mode source-ip-based.
Answer: B,D
NEW QUESTION 20
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. Port2 might become alive when a single response is received from an SLA server
- C. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- D. SD-WAN interface becomes disabled and port1 becomes the WAN interface
Answer: D
NEW QUESTION 21
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- B. A factory reset performed on FortiGate.
- C. The zero-touch provisioning process has completed internally, behind FortiGate.
- D. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- E. The FortiGate cloud key has not been added to the FortiGate cloud portal.
Answer: C,E
NEW QUESTION 22
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- C. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: A,E
NEW QUESTION 23
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- D. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
Answer: C,D
Explanation:
Explanation/Reference:
NEW QUESTION 24
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. A single user uses the allocated bandwidth divided by total number of users.
- B. The 10 Mbps bandwidth is shared equally among the IP addresses.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth.
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Explanation/Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 25
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)
- A. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom
- B. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces
- C. The initial session of an application goes through a learning phase in order to apply the correct rule
- D. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
Answer: C,D
NEW QUESTION 26
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
- B. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
- C. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
- D. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
Answer: B,D
NEW QUESTION 27
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC transmits additional packets as redundant data to the remote device.
- C. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- D. FEC transmits the original payload in full to recover the error in transmission.
- E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
Answer: B,C
NEW QUESTION 28
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. FortiGate has terminated the session after a change on policy ID 1.
- C. Firewall policy ID 1 has source NAT disabled.
- D. Changes have been made on firewall policy ID 1 on FortiGate.
Answer: D
NEW QUESTION 29
Which components make up the secure SD-WAN solution?
- A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- B. Datacenter, branch offices, and public cloud
- C. Telephone, ISDN, and telecom network.
- D. Application, antivirus, and URL, and SSL inspection
Answer: D
NEW QUESTION 30
Refer to exhibits.
Exhibit A.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- B. Both SD-WAN member interfaces have used separate SLA targets.
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
Answer: B
NEW QUESTION 31
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. On the hub VPN, only the device needs additional phase one sett
- B. Each VPN device has a unique pre-shared key configured separately on phase one
- C. The protected subnets should be set to address object to all (0.0 .0. o/o).
- D. ADVPN should only be enabled on unmanaged FortiGate devices.
Answer: B
NEW QUESTION 32
What is the lnkmtd process responsible for?
- A. Processing performance SLA probes
- B. Flushing route tags addresses
- C. Monitoring links for any bandwidth saturation
- D. Logging interface quality information
Answer: C
NEW QUESTION 33
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The reverse shaper option must be enabled and a traffic shaper must be selected
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. The guaranteed-10mbps option must be selected as the per-IP shaper option
- D. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
Answer: B
NEW QUESTION 34
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. Each VPN device has a unique pre-shared key configured separately on phase one.
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one settings.
- D. The protected subnets should be set to address object to all (0.0.0.0/0).
Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION 35
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-lcg
- D. diagnose sys virtual-wan-link log
Answer: A
NEW QUESTION 36
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: B,E
NEW QUESTION 37
......
Practice NSE7_SDW-6.4 Questions With Certification guide Q&A from Training Expert LatestCram: https://actualtests.latestcram.com/NSE7_SDW-6.4-exam-cram-questions.html
